Solenoid Body Assembly

Solenoid Body Assembly











Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the transmission fluid drain plug and drain the transmission fluid.





3. NOTE: Clean the area around transmission control solenoid body harness connector to prevent contamination of the transmission control solenoid body harness connector.

Disconnect the transmission control solenoid body harness connector.





4. NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage. If not damaged, the transmission fluid pan gasket should be reused.

Remove the 16 transmission fluid pan screws, transmission fluid pan and transmission fluid pan gasket.





5. Remove the transmission fluid pan filter.





6. CAUTION: Do not damage the solenoid body connector pins.

Remove the transmission control solenoid body screws and remove the transmission control solenoid body by pulling down on the transmission control solenoid body and pushing down on the transmission solenoid body connector from the other side of the case.





Installation
1. Install new O-ring seals on the transmission control solenoid body connector. Lubricate the O-ring seals with clean transmission fluid.





2. CAUTION: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If damaged, a transmission leak may occur.

Install the transmission control solenoid body. Tighten the transmission control solenoid body screws in sequence shown.
^ Tighten to 8 Nm (71 lb-inch).





3. CAUTION: Damage may occur to transmission fluid filter seals if they are not lubricated with clean transmission fluid.

NOTE: Make sure that the transmission fluid pan filter seals are correctly seated on the transmission fluid pan filter.

Lubricate the transmission fluid pan seals and install the transmission fluid pan filter.
^ Tighten to 10 Nm (89 lb-inch).





4. NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage. If not damaged, the transmission fluid pan gasket should be reused.

Install the transmission fluid pan and transmission fluid pan gasket and loosely install the transmission fluid pan screws.





5. Tighten the transmission fluid pan screws in a crisscross sequence.
^ Tighten to 11 Nm (8 lb-ft).





6. CAUTION: Damage will occur to the transmission control solenoid body assembly if the screw is tightened above the specification.

NOTE: Always install new O-ring seals on transmission control solenoid body harness connector.

NOTE: Clean the area around transmission control solenoid body harness connector to prevent contamination of the transmission control solenoid body harness connector.

NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.

Install and lubricate new O-ring seals on the transmission control solenoid body harness connector and connect the connector.
^ Tighten to 5 Nm (44 lb-inch).





7. Fill the transmission.