Audio Control Module (ACM)

Audio Control Module (ACM)

Without Navigation









With Navigation









Removal and Installation

All vehicles

1. NOTE: Module configuration is only required if a new ACM is being installed.

Upload the ACM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

2. Remove the middle instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

3. Remove the 4 ACM screws.
- To install, tighten to 2 Nm (18 lb-in) (navigation).

- To install, tighten to 1 Nm (9 lb-in) (all except navigation).

Navigation

4. Disconnect the antenna and electrical connectors.

All except navigation

5. NOTE: Only carry out this step if installing a new ACM.

Remove the 2 ACM brackets.

All vehicles

6. Remove the ACM.

7. To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programming and Relearning