Roof Opening Panel Shield

Roof Opening Panel Shield

Removal and Installation

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel motor has been removed from the roof panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

1. Remove the roof opening panel drain trough. For additional information, refer to Trough Assembly Trough Assembly.

2. Slide the roof opening panel shield forward halfway.

3. Disengage the roof opening panel shield guide feet.
- Lift the front portion of the roof opening panel shield upward at center until able to disengage one of the front guide feet.





4. With one of the guide feet released, carefully rotate the roof opening panel shield in a clockwise manner to disengage the remaining guide feet.





5. To install, reverse the removal procedure.
- Verify that the roof opening panel is centered and aligned before tightening the glass screws. For additional information, refer to Roof Opening Panel Alignment Adjustments.

- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.