Alarm System Transponder: Service and Repair

Removal
1. Remove ignition switch lock cylinder from steering column housing.
2. Remove both upper and lower steering column shrouds (three fasteners).
3. Remove screw retaining passive anti-theft (PATS) transceiver module to steering column lock cylinder housing.

Note: Only apply pressure or leverage below the key cylinder lower rib.

4. Locate rib on steering column lock cylinder housing. Use a small screwdriver to gently pry PATS transceiver module over the rib.
5. Disconnect the PATS transceiver module from steering column locators and wiring harness connector and remove transceiver from vehicle.

PATS Transceiver:

Installation
1. Locate post on circular antenna and align to open slot of steering column key cylinder barrel.
2. Apply even pressure to top surface of the PATS transceiver and slide it onto the lock cylinder.
3. Position the rib on transceiver case within the two walls of the cavity on the steering column lock cylinder housing, to prevent movement.

Note: Avoid pinching the transceiver wires with the retaining screw.

4. Install PATS transceiver module retaining screw to steering column lock cylinder housing. Tighten to 2 Nm (18 lb-in).
5. Connect PATS transceiver module to steering column bracket, and connect harness connector.
6. Install the upper and lower steering column shrouds (three fasteners).
7. Install the ignition switch lock cylinder.

Note: No key replacement or re-initialization needs to occur with the removal or installation of a new PATS transceiver module.

8. Check the system for normal operation.