B1213: Number of Programmed Keys Below Minimum

B1213-1 Check For Additional Diagnostic Trouble Codes
- Perform PATS on-demand self-test.
- Check for DTCs B1600, B1601 or B1681.
Is DTC B1213 the only DTC retrieved?
Yes
GO to B1213-2.
No
- REPAIR other DTCs retrieved.
- TEST the system for normal operation.
- REPEAT self-test.

B1213-2 Check PATS PID: NUMKEYS
- Enter NGS: PIDs/Data Monitor and Record Check PID: NUMKEYS. PATS Parameter Identification Index
Did PATS PID: NUMKEYS display less than two encoded ignition keys programmed?
Yes
GO to B1213-3 .
No
- CLEAR DTCs.
- TEST the system for normal operation.

B1213-3 Program In Two Keys

Note: Two programmed encoded keys must be available to start the vehicle.

- Cut new encoded ignition lock cylinder key.
- Insert new encoded ignition key into ignition switch.
- Program the new encoded ignition key. Service and Repair
Does the theft indicator illuminate for three seconds and then go out?
Yes
- CLEAR DTCs and RUN self-test to VERIFY no diagnostic trouble code.
- TEST the system for normal operation.
No
- If the theft indicator is on continuously, REPEAT B1213-3 with second new encoded ignition key.
- TEST the system for normal operation.
- If the theft indicator is flashing, RETRIEVE DTC stored for new fault.
- REPAIR the other DTC(s) retrieved. PATS Diagnostic Trouble Code (DTC) Index