Operation CHARM: Car repair manuals for everyone.

Initial Inspection and Diagnostic Overview

Inspection and Verification

Note:

- The PATS module must be reconfigured after replacement. Refer to the PATS Configuration Command Index. PATS Configuration Command Index
- For additional reprogramming assistance, refer to the help screen on the New Generation STAR (NGS) Tester configuration card.

1. Verify the customer concern by duplicating the condition.
2. Visually inspect to determine if one of the following mechanical or electrical concerns apply:
Mechanical
- Damaged ignition lock cylinder.
- Damaged encoded ignition key.
- A non-encoded ignition key being used.
- A non-programmed encoded ignition.
Electrical
- Open fuses: Fuse junction, Fuse 8 (15A), Fuse 7 (25A)
- Inoperative transceiver module
- Loose connections
- Corroded connections
- Damaged ignition switch.
3. If inspection reveals an obvious concern that can be readily repaired, correct the concern before continuing with Inspection and Verification.
4. If the concern remains after the inspection, connect the New Generation STAR (NGS) Tester to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the NGS menu.
If the NGS does not communicate with the vehicle:
- Check that the program card is properly installed.
- Check the connections to the vehicle.
- Check the ignition switch position.
5. If the NGS still does not communicate with the vehicle, refer to the New Generation STAR Tester manual.
6. Perform the DATA LINK DIAGNOSTIC TEST.
If the NGS responds with:
- CKT914, CKT915 or CKT70 = ALL ECUS NO RESP/NOT EQUIP, refer to the Multiplex Communication Network. Testing and Inspection
- NO RESP/NOT EQUIP for PATS module, go to Pinpoint Test A. A: No Communication With Passive Anti-Theft System Module
- SYSTEM PASSED, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and perform self-test diagnostics for the PATS module.
7. If the DTCs retrieved are related to the concern, go to PATS Diagnostic Trouble Code (DTC) Index to continue diagnostics. PATS Diagnostic Trouble Code (DTC) Index
8. If no DTCs related to the concern are retrieved, proceed to Symptom chart to continue diagnostics. Symptom Related Diagnostic Procedures

Note: Rotunda SBDS� 418-F001 (001-00001) may also be used to diagnose this system.