Front Seat Assembly Removal and Installation

REMOVAL AND INSTALLATION

CAUTION:
Before removing the front seat assembly, refer to Service Precautions Service Precautions and Side Airbag Module (s) Removal and Installation.









REMOVAL SERVICE POINT

[[A]] WIRING HARNESS CONNECTORS DISCONNECTION





Disconnect the following wiring harness connectors:










NOTE:
When disconnecting the side air bag module connectors of D-32 and D-39, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.

INSTALLATION SERVICE POINT

]]A[[ FRONT SEAT ASSEMBLY INSTALLATION





1. Confirm that both the seat slides are locked, and then temporarily tighten all the bolts shown in the figure so that no load is applied to the front seat cushion.
2. Tighten all the bolts to the specified torque.
Tightening torque: 43± 8Nm