Combination Switch: Service and Repair

REMOVAL AND INSTALLATION

[LIGHTING SWITCH AND WIPER/WASHER SWITCH]









[COLUMN SWITCH BODY]

CAUTION:

- To remove the driver air bag module, refer to Service Precautions Service Precautions and Driver's Air Bag Module(s) and Clock Spring Removal and Installation .
- When the steering wheel sensor is replaced, always carry out calibration to make ASC-ECU learn the neutral point. Testing and Inspection .)[ Vehicles with ASC]













REMOVAL SERVICE POINTS

[[A]] COLUMN SWITCH BODY REMOVAL





1. Using a wrench or similar tool, pinch and lift the band clump pin shown in the figure.









2. With the flat-tipped screwdriver inserted into the column shaft groove shown in the figure, lift the claw shown in Section A-A, and then remove the column switch body by pulling out the switch body.

INSTALLATION SERVICE POINT

]]A[[ COLUMN SWITCH BODY INSTALLATION





1. Using a wrench or similar tool, pinch and lift the band clump pin shown in the figure.
2. Align the part "A" position in the figure with the steering lock side rib, and then insert the switch body into the column shaft.
3. After mounting the column switch body by securely fitting the column switch body claw with the column shaft groove, release the band clump pin.