Vehicle Speed Sensor-A/T (Revolution Sensor) Circuit Check

DESCRIPTION







The revolution sensor detects the revolution of the idler gear and emits a pulse signal. The pulse signal is sent to the A/T control unit which converts it into vehicle speed.

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE


With Consult




After the repair, perform the following procedure to confirm the malfunction is eliminated.
(1) Start engine.
(2) Select "SELF-DIAG RESULTS" mode with CONSULT
(3) Drive vehicle under the following conditions: Selector lever in D, vehicle speed higher than 30 km/h (19 MPH), throttle opening greater than 1/8 of the full throttle position and driving for more than 5 seconds.

OR


With GST




(1) Start engine.
(2) Drive vehicle under the following conditions: Selector lever in D, vehicle speed higher than 30 km/h (19 MPH), throttle opening greater than 1/8 of the full throttle position and driving for more than 5 seconds.
(3) Select "MODE 3" with GST

OR

Without Scan Tools




(1) Start engine.
(2) Drive vehicle under the following conditions: Selector lever in D, vehicle speed higher than 30 km/h (19 MPH), throttle opening greater than 1/8 of the full throttle position and driving for more than 5 seconds.
(3) Perform self-diagnosis.


DIAGNOSTIC PROCEDURE





REVOLUTION SENSOR
Resistance Inspection







- Check resistance between terminals (1), (2) and (3) as shown above.