P0725

DTC P0725 ENGINE SPEED SIGNAL

Description
The engine speed signal is sent from the ECM to the TCM.





CONSULT-II Reference Value

On Board Diagnosis Logic
- This is not an OBD-II self-diagnostic item.
- Diagnostic trouble code P0725 ENGINE SPEED SIG with CONSULT-II or 16th judgement flicker without CONSULT-II is detected when TCM does not receive the ignition signal from ECM during engine cranking or running.

Possible Cause
- Harness or connectors (The ECM to the TCM circuit is open or shorted.)

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If DTC Confirmation Procedure has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II





1. Turn ignition switch ON and select DATA MONITOR mode for A/T with CONSULT-II.
2. Start engine and maintain the following conditions for at least 10 consecutive seconds.
VHCL SPEED SE: 10 km/h (6 MPH) or more
ACCELE POSI: More than 1/8
Selector lever: D position
3. If DTC is detected, go to AT-118, Diagnostic Procedure.

Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to AT-87, SELF-DIAGNOSTIC RESULT MODE. With Manufacturer's Scan Tool
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line. Refer to AT-100, DTC U1000 CAN COMMUNICATION LINE. U1000
NO >> GO TO 2.

2. CHECK DTC WITH TCM

With CONSULT-II





1. Start engine.
2. Select ECU INPUT SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.
3. While monitoring engine speed, check for engine speed change corresponding to wide-open throttle position signal.
OK or NG
OK >> GO TO 3.
NG >> Check the ignition signal circuit.
- Refer to IGNITION SIGNAL.

3. CHECK DTC
Perform DTC Confirmation Procedure. Refer to AT-117, DTC Confirmation Procedure.
OK or NG
OK >> INSPECTION END
NG >> GO TO 4.

4. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to MAIN POWER SUPPLY AND GROUND CIRCUIT.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.

5. DETECT MALFUNCTIONING ITEM
Check the following.
The A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace the control valve with TCM. Refer to Control Valve With TCM and A/T Fluid Temperature Sensor 2.
NG >> Repair or replace damaged parts.