CONSULT-II Setting Procedure

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

NOTE: For details, refer to the separate "CONSULT-II Operations Manual".

1. Turn ignition switch "OFF".





2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector on vehicle.
3. Turn ignition switch "ON".





4. Touch "START (NISSAN BASED VHCL)".





5. Touch "ALL MODE AWD/4WD".
If "ALL MODE AWD/4WD" is not indicated, go to GI-41, "CONSULT-II Data Link Connector (DLC) Circuit". Electrical Diagrams
6. Perform each diagnostic test mode according to each service procedure.