With Intelligent Key System

DOOR SWITCH


Description

Detects door open/close condition.




DOOR SWITCH


Diagnosis Procedure

1.CHECK DOOR SWITCHES INPUT SIGNAL
With CONSULT-III
Check door switches ("DOOR SW-DR", "DOOR SW-AS", "DOOR SW-RL", "DOOR SW-RR", "BACK DOOR SW") in DATA MONITOR mode with CONSULT�III.
- When doors are open:





- When doors are closed:






Without CONSULT-III
Check voltage between BCM connector M18 or M19 terminals 12, 13, 43, 47, 48 and ground.










Is the inspection result normal?
YES - Door switch circuit is OK.
NO - GO TO 2
2.CHECK DOOR SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door switch and BCM.
3. Check continuity between BCM connector (A) M18, M19 terminals 12, 13, 43, 47, 48 and door switch connector (B) B8 (Front LH), B108 (Front RH), B18 (Rear LH), B116 (Rear RH) terminal 2 or back door latch connector (C) D503 terminal 7.






4. Check continuity between door switch connector (B) B8 (Front LH), B108 (Front RH), B18 (Rear LH), B116 (Rear RH) terminal 2 or back door latch connector (C) D503 terminal 7 and ground.











Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace harness.
3.CHECK DOOR SWITCHES
- Disconnect door switch harness.
- Check continuity between door switch connector terminals.










Is the inspection result normal?
YES - Door switch circuit is OK.
NO - (Front and rear doors) Replace door switch.
NO - (Back door) GO TO 4
4.CHECK BACK DOOR SWITCH CIRCUIT
- Check continuity between door switch connector terminal and ground.










Is the inspection result normal?
YES - Replace back door switch.
NO - Repair or replace harness.