Diagnosis Procedure

TOUCH SENSOR


RH : Description

The touch sensor RH is installed on the right edge of the back door, and it detects any trapped foreign material in the back door during the auto close operation and at the closure operation.





TOUCH SENSOR


RH : Diagnosis Procedure

1.CHECK AUTOMATIC BACK DOOR CONTROL UNIT OUTPUT
1. Turn ignition switch OFF.
2. Disconnect touch sensor RH connector.
3. Check voltage between touch sensor RH harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK TOUCH SENSOR RH CIRCUIT
1. Disconnect automatic back door control unit connector.
2. Check continuity between automatic back door control unit harness connector and touch sensor RH harness connector.





3. Check continuity between automatic back door control unit harness connector and ground.





Is the inspection result normal?
YES - Replace automatic back door control unit. Removal And Installation.
NO - Repair or replace harness.
3.CHECK TOUCH SENSOR RH GROUND CIRCUIT
Check continuity between automatic back door control unit harness connector and touch sensor RH harness connector.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK TOUCH SENSOR RH
Component Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace touch sensor RH. Removal And Installation.
5.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END