Body Control Module: Service and Repair
BCM (BODY CONTROL MODULE)
Removal and Installation
REMOVAL
NOTE:
If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Special Repair Requirement.
1. Disconnect the battery negative terminal.
2. Remove the lower instrument panel LH. Exploded View.
3. Remove the BCM screws and release the BCM.
4. Disconnect the BCM connectors and then remove the BCM.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
- When replacing the BCM, it must be configured. Special Repair Requirement.
- When replacing the BCM, perform initialization of NATS system and registration of all NATS ignition key IDs. Special Repair Requirement.
- When replacing the BCM, perform ID registration procedure of low tire pressure warning system. ID Registration Procedure.
- When replacing the BCM, register the remote keyless entry system keyfob ID codes. Special Repair Requirement.
- When replacing the BCM, perform adjustment procedure for the steering angle sensor. Type 1 - VDC/TCS/ABS(Type 1) or Type 2 - Hill Descent Control/Hill Start Assist/VDC/TCS/ABS (Type 2).