Rear Door Window Regulator: Service and Repair

REAR DOOR GLASS AND REGULATOR


Rear Door Glass Regulator


REMOVAL
1. Remove the rear door finisher. Service and Repair.
2. Position the vapor barrier aside.
3. Temporarily reconnect the power window switch.





4. Operate the power window switch to raise/lower the door window until the glass bolts can be seen.
5. Raise the rear door glass and hold it in place with suitable tool.
6. Remove the bolts and the regulator assembly.
- Disconnect the connector from the regulator assembly.





White Arrow indicates Front

INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Gear wear
- Regulator deformation
- Spring damage
- Grease condition for each sliding part

INSTALLATION





White Arrow indicates Front

1. Connect the harness connector and install the regulator assembly.
a. Loosely install the top rear regulator bolt to use along with the temporary holds on the window motor to install the assembly in the door.
b. Install the top front regulator bolt.
c. Install the bottom regulator bolt.
d. Tighten the top rear regulator bolt.
e. Install the top window motor bolt.
f. Install the lower window motor bolt.
g. Install the front window motor bolt.

Regulator assembly : 7.5 N.m (0.77 kg-m, 66 in-lb)






2. Lower the glass and ensure that it is in both the front and rear glass channels. Tighten the bolts.

Glass bolts : 5.7 N.m (0.58 kg-m, 50 in-lb)

3. Install the partition sash
4. Check the glass alignment.
5. Reposition the vapor barrier.
6. Install the rear door finisher. Service and Repair.