Door Switch
DOOR SWITCH
Description
Detects door open/close condition.
Component Function Check
1.CHECK FUNCTION
With CONSULT-III
Check door switches in data monitor mode with CONSULT-III.
Is the inspection result normal?
YES - Door switch is OK.
NO - SEE Diagnosis Procedure.
Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1.CHECK DOOR SWITCHES INPUT SIGNAL
With CONSULT-III
Check door switches ("DOOR SW-DR", "DOOR SW-AS", "DOOR SW-RL", "DOOR SW-RR", "BACK DOOR
SW") in DATA MONITOR mode with CONSULT-III.
- When doors are open:
- When doors are closed:
Without CONSULT-III
Check voltage between BCM connector M18 or M19 terminals 12, 13, 43, 47, 48 and ground.
Is the inspection result normal?
YES - Door switch circuit is OK.
NO - GO TO 2
2.CHECK DOOR SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door switch and BCM.
3. Check continuity between BCM connector M18, M19 terminals 12, 13, 43, 47, 48 and door switch connector B8 (Front LH), B108 (Front RH), B18 (Rear LH), B116 (Rear RH) terminal 2 or back door latch connector D502 terminal 3.
4. Check continuity between door switch connector B8 (Front LH), B108 (Front RH), B18 (Rear LH), B116 (Rear RH) terminal 2 or back door latch connector (C) D502 terminal 3 and ground.
Is the inspection result normal?
YES - GO TO 3 (front and rear door).
YES - GO TO 4 (back door).
NO - Repair or replace harness.
3.CHECK FRONT AND REAR DOOR SWITCHES
Check continuity between door switch terminal 2 and exposed metal of switch while pressing and releasing switch.
Is the inspection result normal?
YES - Door switch circuit is OK.
NO - Replace door switch.
4.CHECK BACK DOOR SWITCH
Check continuity between door switch terminals.
Is the inspection result normal?
YES - Repair or replace back door switch ground circuit.
NO - Replace back door switch.