Body Control Module: Service and Repair

BCM (BODY CONTROL MODULE)


Removal and Installation


REMOVAL

NOTE:
If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Description Special Repair Requirement Description, "ADDITIONAL SERVICE WHEN REPLACING CONTROL
UNIT : Special Repair Requirement".
1. Disconnect the battery negative terminal.
2. Remove the instrument lower panel LH. Exploded View.





3. Remove the BCM screws and release the BCM.
4. Disconnect the BCM connectors and then remove the BCM.

INSTALLATION
Installation is in the reverse order of removal.
NOTE:
- When replacing the BCM, it must be configured. Special Repair Requirement, "CONFIGURATION : Special Repair
Requirement".
- When replacing the BCM, perform initialization of NATS system and registration of all NATS ignition key IDs.
Special Repair Requirement.
- When replacing the BCM, perform ID registration procedure of low tire pressure warning system. Refer to
ID Registration Procedure.
- When replacing the BCM, register the remote keyless entry system keyfob ID codes. Description Special Repair Requirement Description, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
- When replacing the BCM, perform adjustment procedure for the steering angle sensor. Type 1(Type 1) or Type 2 (Type 2).