Memory Positioning Module: Service and Repair

AUTOMATIC DRIVE POSITIONER CONTROL UNIT

Removal and Installation


REMOVAL


CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1.Disconnect the battery negative terminal. Procedures.
2.Remove the instrument driver lower panel. Removal And Installation.





3.Remove the automatic drive positioner control unit.
a.Remove the automatic drive positioner control unit screw (1).
b.Separate the automatic drive positioner control unit from the bracket.
c.Disconnect the electrical connectors and remove automatic drive positioner control unit.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
Clamp the harness in position.
NOTE:
After installing the automatic drive positioner control unit, perform additional service when disconnecting battery negative terminal. Special Repair Requirement.