Keyless Entry Receiver: Service and Repair
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
REMOVAL
1.Remove the front pillar upper finisher (RH). Component.
2.Remove the side ventilator grille (RH). Exploded View.
3.Remove the instrument side finisher. Exploded View.
4.Remove the upper glove box. Exploded View.
5.Remove the bolt (A), disconnect the harness connector (1) and remove the remote keyless entry receiver (2).
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
- When replacing the remote keyless entry receiver, perform ID registration procedure of low tire pressure warning system. ID Registration Procedure.