Self-Diagnosis Function (Without CONSULT)

ON BOARD DIAGNOSTIC (OBD) SYSTEM

Self-Diagnosis Function (Without CONSULT)

- The reading of these results is accomplished using one of two modes -"User mode" and "Diagnosis mode".
- After a malfunction is repaired, turn the ignition switch OFF for at least one second, then back ON. Diagnosis mode returns to the User mode. At that time, the self-diagnostic result is cleared.

HOW TO CHANGE SELF-DIAGNOSIS MODE







DIAGNOSTIC PROCEDURE 3

Final Check of SRS Using CONSULT-Diagnosis Mode
1.Connect CONSULT.
2.If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3.
If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to
Component Tests and General Diagnostics.
3.Touch "ERASE".
NOTE:
Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
4.Touch "BACK" key of CONSULT. Touch "SELF-DIAG [PAST]".
5.Check that no malfunction is detected on "SELF-DIAG [PAST]".
6.Touch "BACK" key of CONSULT to return to User mode from Diagnosis mode.
7.Turn ignition switch OFF and then turn off and disconnect CONSULT.
8.Go to Component Tests and General Diagnostics.

DIAGNOSTIC PROCEDURE 4

Check SRS Repair History

1. CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR

Check repair history of the SRS.
Have any previous repairs been made to the SRS?
YES- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair. Perform DIAGNOSTIC PROCEDURE 3. .
NO- Perform DIAGNOSTIC PROCEDURE 2. Component Tests and General Diagnostics.