Removal And Installation

GENERATOR

Removal and Installation

NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Disconnect the negative battery terminal. Removal and Replacement.
2.Partially drain the engine coolant. Service and Repair.
3.Remove engine room cover.
4.Remove air duct and resonator assembly. Exploded View.
5.Remove upper radiator hose.
6.Disconnect coolant reservoir hose from radiator.
7.Remove the crankcase ventilation hose.
8.Remove the fan shroud. Exploded View.
9.Remove engine cooling fan (Motor Driven Type). Removal And Installation (Motor Driven Type).
10.Remove the drive belt. Removal And Installation.
11.Remove the generator stay, using power tools.
12.Remove the generator upper bolt, using power tools.
13.Disconnect the generator harness connectors.
14.Remove the generator.

INSTALLATION

Installation is in the reverse order of removal.
- Install the generator and check tension of drive belt. Procedures.
Terminal nut: 10.8 Nm (1.1 kg-m, 8 ft-lb)

CAUTION:
Tighten terminal nut carefully.
- For this model, the power generation variable voltage control system that controls the power generation voltage of the generator has been adopted. Therefore, the power generation variable voltage control system inspection should be performed after replacing the generator in order to ensure that the system operates normally. Power Generation Voltage Variable Control System Operation Inspection.