Rear Door Window Regulator: Service and Repair

REAR DOOR GLASS AND REGULATOR

Rear Door Glass Regulator


REMOVAL

1.Remove the rear door finisher. Service and Repair.
2.Remove the rear door handle bracket.
3.Position the vapor barrier aside.
4.Temporarily reconnect the power window switch.





5.Operate the power window switch to raise/lower the door window until the glass bolts can be seen.





6.Raise the rear door glass and hold it in place with suitable tool (A).
7.Remove the bolts and the regulator assembly.
- Disconnect the connector from the regulator assembly.











INSPECTION AFTER REMOVAL

Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Gear wear
- Regulator deformation
- Spring damage
- Grease condition for each sliding part

INSTALLATION











1.Connect the harness connector and install the regulator assembly.
a.Loosely install the top rear regulator bolt to use along with the temporary holds on the window motor to install the assembly in the door.
b.Install the top front regulator bolt.
c.Install the bottom regulator bolt.
d.Tighten the top rear regulator bolt.
e.Install the top window motor bolt.
f.Install the lower window motor bolt.
g.Install the front window motor bolt.
Regulator assembly: 7.5 Nm (0.77 kg-m, 66 in-lb)





2.Lower the glass and ensure that it is in both the front and rear glass channels. Tighten the bolts.
Glass bolts: 6.1 Nm (0.62 kg-m, 54 in-lb)
3.Install the partition sash
4.Check the glass alignment.
5.Install the rear door handle bracket.
6.Reposition the vapor barrier.
7.Install the rear door finisher. Service and Repair.