DTC 1003

When the gear position is "P" (A/T models only) or "N", park/neutral position is "ON".
ECM detects the position because the continuity of the line (the "ON" signal) exists.
ECM receives signals from park position switch via A/T control unit.




OVERALL FUNCTION CHECK
Use this procedure to check the overall function of the park/neutral position switch, During this check, a 1st trip DTC might not be confirmed.

With Consult
(1) Turn ignition switch "ON".




(2) Perform "PARK/NEUT POSI SW CKT" in "FUNCTION TEST" mode with CONSULT.

OR

With Consult
(2) Select "P/N POSI 5W" in "DATA MONITOR" mode with CONSULT.




(3) Check the "P/N POSI SW" signal under the following conditions.

Condition (Gear Position) / Known good signal
"N" and "P" (A/T only) position / ON
Except the above position / OFF

OR

Without Consult
(1) Turn ignition switch "ON".




(2) Check voltage between ECM terminal (22) and body ground under the following conditions.

Condition (Gear Position) / Voltage(V)(Known good signal)
"N" and "P" (A/T only) position / Approx. 0
Except the above position / Approx. 5

EC-PNP/SW-01 Park/Neutral Position Switch (DTC P0705):

WIRING DIAGRAM




DIAGNOSTIC PROCEDURE M/T




DIAGNOSTIC PROCEDURE A/T