How to Switch Diagnostic Test Modes

HOW TO SWITCH DIAGNOSTIC TEST MODES
The following emission-related diagnostic information is cleared from the ECM memory in the mode obtained.
1. Diagnostic trouble codes
2. 1st trip diagnostic trouble codes
3. Freeze frame data
4. 1st trip freeze frame data
5. System readiness test (SRT) codes
6. Test values
7. Others
- Switching the modes is not possible when the engine is running.
- When ignition switch is turned oft during diagnosis, power to ECM will drop after approx. 5 seconds. The diagnosis will automatically return to Diagnostic Test Mode I.
- Turn back diagnostic test mode selector to the fully counterclockwise position whenever vehicle is in use.

DIAGNOSTIC TEST MODE I-BULB CHECK
These diagnostic Trouble code numbers are clarified in Diagnostic Test Mode II (SELF-DIAGNOSTIC RESULTS).
In this mode, the MALFUNCTION INDICATOR LAMP on the instrument panel should stay ON. If it remain OFF, check the bulb.




DIAGNOSTIC TEST MODE I-MALFUNCTION WARNING

DIAGNOSTIC TEST MODE II - SELF-DIAGNOSTIC RESULTS
In this mode, the DTC and 1st trip DTC are indicated by the number of blinks of the MALFUNCTION INDICATOR LAMP.
The DTC and 1st trip DTC are displayed at the same time. If the MIL does not illuminate in diagnostic test mode 1 (Malfunction warning), all displayed items are 1st trip DTC's. If only one code is displayed when the MIL illuminates in diagnostic test mode II (SELF-DIAGNOSTIC RESULTS), it is a DTC; if two or more codes are displayed, they may be either DTC's or 1st trip DTC's. DTC No. is same as that of 1st trip DTC. These unidentified codes can be identified by using the consult or GST. A DTC will be used as an example for how to read a code.







Long (0.6 second) blinking indicates the two LH digits of number and short (0.3 second) blinking indicates the two RH digits of number. For example, the malfunction indicator lamp blinks 10 times for 6 seconds (0.6 sec x 10 times) and then it blinks three times for about 1 second (0.3 sec x 3 times). This indicates the DTC "1003" and refers to the malfunction of the park/neutral position switch.
In this way, all the detected malfunctions are classified by their diagnostic trouble code numbers. The DTC "0505" refers to no malfunction.

DIAGNOSTIC TEST MODE II - FRONT HEATED OXYGEN SENSOR MONITOR
In this mode, the MALFUNCTION INDICATOR LAMP displays the condition of the fuel mixture (lean or rich) which is monitored by the front heated oxygen sensor.
To check the front heated oxygen sensor function, start engine in the Diagnostic Test Mode II and warm it up until engine coolant temperature indicator points to the middle of the gauge.
Next run engine at about 2,000 rpm for about 2 minutes under no-load conditions. Then make sure that the MALFUNCTION INDICATOR LAMP comes ON more than 5 times within 10 seconds with engine running at 2,000 rpm under no-load.

How to switch monitored sensor from left bank to right bank or vice versa




The following procedure should be performed while the engine is running.
1. Turn diagnostic test: mode selector on ECM fully clockwise.
2. Wait at least 2 seconds.
3. Turn diagnostic test: mode selector on ECM fully counterclockwise.