Removal and Installation

REMOVAL
1. Remove the front door finisher. Refer to "Front Door".
2. Remove the door speaker. Refer to "DOOR SPEAKER".




3. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
4. Remove the glass mounting bolts.




5. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the outside of the door.




6. Remove the mounting bolts, and remove the module assembly.
7. Disconnect the harness connector for the module assembly, and unclip the harness from the back.

INSTALLATION
Install in the reverse order of removal.
Reset Limit Switch after Installation: Programming and Relearning




INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction
is detected, replace or grease it.
- Wire wear
- Regulator deformation
- Grease condition for each sliding part

The arrows in the figure show the application points of the body
grease.