Diagnostic Procedure 7
Final checking after repairing SRS by using AIR BAG warning lamp - Diagnosis mode and User mode1. After repairing SRS connect both battery cables.
2. Turn ignition switch from OFF to ON.
3. AIR BAG warning lamp operates in Diagnosis mode as follows:
NOTE: When diagnosis sensor unit is replaced with new one, AIR BAG warning lamp will operate in User mode. Checking AIR BAG warning lamp operation in Diagnosis mode is not required. Go to step 6.
4. If AIR BAG warning lamp operates as shown in No. 1 in chart , turn ignition switch OFF to reset from Diagnosis mode to User mode and to erase the memory of the malfunction. Then go to step 6.
If AIR BAG warning lamp operates as shown in No. 2 or No. 3 in chart , the malfunctioning part is not repaired completely, or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 6, and repair malfunctioning part completely.
Diagnostic Procedure 6
5. Turn ignition switch ON. AIR BAG warning lamp operates in User mode. Compare AIR BAG warning lamp operation to the chart.
NOTE: If switching Diagnosis mode to User mode is required while malfunction is being detected, perform following procedures:
1. Turn ignition switch ON.
2. After AIR BAG warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
3. Wait more than 3 seconds.
4. Repeat steps 1 to 3 two times. (Perform 3 times in total.)
5. Turn ignition switch ON.
SRS is now in User mode.