Diagnostic Procedure 2
DIAGNOSTIC PROCEDURE 2 / With CONSULT-II Scan ToolInspecting SRS malfunctioning parts by using CONSULT-II - Diagnosis mode
1. Turn ignition switch "OFF".
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch "ON".
4. Touch "START".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [CURRENT]".
7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".
If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check" ([1][2]Component Tests and General Diagnostics), refer to "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2)"(Diagnostic Procedure 4), to diagnose the following cases:
* Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
* The SRS system malfunctions intermittently.
8. Touch "PRINT".
9. Compare diagnostic codes. Refer to "CONSULT-II Diagnostic Code Chart".
CONSULT-II Display Items ("Self-Diag [Current]")
10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
11. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II and disconnect both battery cables.
12. Repair the system as outlined by the "Repair order" in "CONSULT-II Diagnostic Code Chart", that corresponds to the self-diagnostic result.
13. After repairing the system, refer to "DIAGNOSTIC PROCEDURE 3" for final checking.
Diagnostic Procedure 3