Diagnostic Procedure 5

DIAGNOSTIC PROCEDURE 5 / With CONSULT-II Scan Tool

Inspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode
1. Turn ignition switch "OFF".






2. Connect CONSULT-II to data link connector.






3. Turn ignition switch "ON".
4. Touch "START".






5. Touch "AIR BAG".






6. Touch "SELF-DIAG [PAST]".






7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.






If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".






8. Touch "TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.






9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".

10. Touch "PRINT".

11. Compare diagnostic codes to SRS-25, "Intermittent Malfunction Diagnostic Code Chart ("SELF-DIAG [PAST]" or "TROUBLE DIAG RECORD")" .

12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.

13. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II, and both battery cables.

14. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.


15. Go to "DIAGNOSTIC PROCEDURE 3" , for final checking.
Diagnostic Procedure 3