P1229
DTC P1229 SENSOR POWER SUPPLYOn Board Diagnosis Logic:
On Board Diagnosis Logic
Fail-Safe Mode:
FAIL-SAFE MODE
DTC Confirmation Procedure
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for 1 second.
4. If DTC is detected, go to "Diagnostic Procedure" below.
WITH GST
Follow the procedure "WITH CONSULT-II" above.
EC-SEN/PW-01:
Wiring Diagram
Diagnostic Procedure
Diagnostic Procedure (Steps 1 - 2):
