Lock-Up Is Not Released

Without Scan ToolLock-up Is Not Released

SYMPTOM:
The lock-up condition cannot be cancelled even after releasing the accelerator pedal.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Refer to AT-94, "SELF-DIAGNOSTIC RESULT MODE", With Manufacturer's Scan Tool AT-104, "Diagnostic Procedure Without CONSULT-II". Without Scan Tool

Is any malfunction detected by self-diagnostic results?
YES >> Check the malfunctioning system. Refer to "SELF-DIAGNOSTIC RESULT MODE", "Judgement Self-diagnosis Code".
NO >> GO TO 2.

2. CHECK SYMPTOM
Check again. Refer to "Cruise Test - Part 1".

OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK TCM
1. Check TCM input/output signals. Refer to "TCM Input/Output Signal Reference Values".
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.

OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.