P0613
DTC P0613 TCM PROCESSORDescription
The TCM consists of a microcomputer and connectors for signal input and output and for power supply. The TCM controls the A/T.
On Board Diagnosis Logic
- This is not an OBD-II self-diagnostic item.
- Diagnostic trouble code "TCM PROCESSOR" with CONSULT-II is detected when TCM processor is malfunctioning.
Possible Cause
- TCM
DTC Confirmation Procedure
NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.
After the repair, perform the procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "A/T" with "DATA MONITOR" mode in CONSULT-II.
3. Start engine.
4. Run engine for at least 2 consecutive seconds at idle speed.
5. If DTC is detected, go to AT-471, "Diagnostic Procedure".
Diagnostic Procedure
1. CHECK DTC
With CONSULT-II
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "A/T" with "SELF-DIAG RESULTS" mode in CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Perform DTC confirmation procedure, AT-470, "DTC Confirmation Procedure".
Is the "TCM PROCESSOR" displayed again?
YES >> Replace TCM.
NO >> Inspection End.