Diagnostic Procedure 2
DIAGNOSTIC PROCEDURE 2CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected in self-diagnosis depending on control unit which carry out CAN communication.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [CURRENT]".
7. Diagnostic code is displayed on "SELF-DIAG [CURRENT]".
If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", refer to "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2)" , to diagnose the following cases:
- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]") Part 1:
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]") Part 2:
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]") Part 3:
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]") Part 4:
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]")