1. Check Before Engine Is Started
1. CHECK BEFORE ENGINE IS STARTED1. CHECK O/D OFF INDICATOR LAMP
1. Park vehicle on flat surface.
2. Move A/T selector lever to P position.
3. Turn ignition switch to OFF position. Wait at least 5 seconds.
4. Turn ignition switch to ON position. (Do not start engine.)
5. Does O/D OFF indicator lamp come on for about 2 seconds?
Yes or No
Yes >> GO TO 2.
No >> Stop ROAD TEST. Go to AT-220, 1. O/D OFF Indicator Lamp Does Not Come On. O/D Off Indicator Lamp Does Not Come on
2. CHECK O/D OFF INDICATOR LAMP
Does O/D OFF indicator lamp flicker for about 8 seconds?
Yes or No
Yes >> TCM is in fail-safe mode. Perform self-diagnosis and check NG items on the AT-58, Diagnostic Worksheet. Introduction
Refer to AT-51, TCM Self-diagnostic Procedure (No Tools). Without Scan Tool
No >>
1. Turn ignition switch to OFF position.
2. Perform self-diagnosis and note NG, items. Refer to AT-51, TCM Self-diagnostic Procedure (No Tools). Without Scan Tool
3. Go to AT-71, 2. CHECK AT IDLE. 2. Check at Idle