Perform Adjustment of Stroke Sensor

PERFORM ADJUSTMENT OF STROKE SENSOR: Description
After removing or adjusting brake stroke sensor, adjustments are necessary.

PERFORM ADJUSTMENT OF STROKE SENSOR: Special Repair Requirement
1. Clear the stored value of stroke sensor data.
a. Connect the connector to the brake stroke sensor.
b. Connect the CONSULT-III with the ignition switch OFF.
c. Turn the ignition switch ON.
d. Reading the "STROKE SEN" value shown in the DATA MONITOR, slowly turn the brake stroke sensor to the right and left to adjust the value to the standard voltage.
Standard voltage: 0.8 to 1.2 V
e. Fully tighten the mounting bolts.

CAUTION:
Do not depress the brake pedal after turning the ignition switch ON.

f. Move the shift lever to the P position.
g. Turn the ignition switch ON with the brake pedal released.
h. Clear the stored value of stroke sensor.
i. Using the CONSULT-III, perform adjustment of stroke sensor.
2. Perform the adjustment of stroke sensor.
a. Turn the ignition switch OFF.
b. Connect the CONSULT-III.
c. Move the shift lever to the P position.
d. Turn the ignition switch ON (READY) with the brake pedal depressed.

NOTE:
^ If the stroke sensor offset learning is performed without turning the ignition switch ON, the learning process may not be completed properly because of insufficient auxiliary battery voltage.
^ When the stroke sensor offset learning is interrupted, or the learning process is performed with the shift lever not in the P position.

e. Select "TEST MODE" in "WORK SUPPORT" to start TEST MODE.
f. Leave the vehicle stationary without depressing the brake pedal for 1 to 2 minutes.
g. Check that the interval between blinks of the Electronically Controlled Brake warning lamp.

NOTE:
^ The time needed to complete adjustment of stroke sensor varies depending on auxiliary battery voltage.
^ The Electronically Controlled Brake warning lamp blinks at 1 second interval during adjustment of stroke sensor.

h. Select "TEST MODE END".