C1610

DTC C1610 CAN ENG RPM

CONSULT-III REFERENCE VALUE IN DATA MONITOR MODE:

DIAGNOSTIC PROCEDURE

1. CHECK DTC WITH ECM
Perform self -diagnosis with ECM. Refer to EC-109, "CONSULT-II Function (ENGINE)". CONSULT-II Function (Engine)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system.
NO >> GO TO 2.

2. CHECK EPS CONTROL UNIT
Check EPS control unit input/output signal. Refer to STC-9, "EPS Control Unit Input/Output Signal Reference Value". EPS Control Unit Input/Output Signal Reference Value
OK or NG
OK >> GO TO 3.
NG >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

3. CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Perform self-diagnosis with ECM again. Refer EC-109, "CONSULT-II Function (ENGINE)". CONSULT-II Function (Engine)