P2103
DTC P2100, P2103 THROTTLE CONTROL MOTOR RELAYComponent Description
Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM.
CONSULT-II Reference Value in Data Monitor Mode
On Board Diagnosis Logic
FAIL-SAFE MODE
DTC Confirmation Procedure
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
PROCEDURE FOR DTC P2100
With CONSULT-II
1. Turn ignition switch ON and wait at least 2 seconds.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for 5 seconds.
4. If DTC is detected, go to "Diagnostic Procedure" below.
With GST
Follow the procedure "With CONSULT-II".
PROCEDURE FOR DTC P2103
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.
With CONSULT-II
1. Turn ignition switch ON and wait at least 1 second.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. If DTC is detected, go to "Diagnostic Procedure" below.
With GST
Follow the procedure "With CONSULT-II".
Wiring Diagram
EC-ETC2-01:
Diagnostic Procedure
Step 1-2:
