Engine Cannot Be Started In "P" and "N" Position
Engine Cannot Be Started in "P" and "N" PositionSYMPTOM:
^ Engine cannot be started with selector lever in "P" or "N" position.
^ Engine can be started with selector lever in "D", "2", "1" or "R" position.
DIAGNOSTIC PROCEDURE
1. CHECK PNP SWITCH
Check continuity between PNP switch harness connector terminals.
OK or NG
OK >> GO TO 3.
NG >> GO TO 2.
2. CHECK PNP SWITCH
Check PNP switch again with control cable disconnected from manual shaft of A/T assembly. Refer to test group 1.
OK or NG
OK >> Adjust A/T position. Refer to AT-207, "Adjustment of A/T Position". Adjustments
NG >> 1. Check PNP switch (Refer to test group 1.) again after adjusting PNP switch (Refer to AT-219). Service and Repair
- If OK, INSPECTION END
- If NG, repair or replace PNP switch.
3. CHECK STARTING SYSTEM
Check starting system.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.