Shifter M/T: Service and Repair
CONTROL LINKAGEMT-13 Component:
Removal and Installation
REMOVAL
1. Remove battery.
2. Remove air duct (Inlet), air duct and air cleaner case.
3. Remove shift cable from shift lever.
4. Remove select cable according to the following.
a. Move stopper (1) to the unlocked position.
b. Pull the release button (1) of select cable (2) and then remove it from select lever (3).
5. Shift control lever to neutral position.
6. Remove control lever knob.
7. Remove center console assembly.
8. Remove control device assembly bolts.
9. Remove exhaust front tube, center muffler and heat plate.
10. Remove cable support bracket.
11. Remove select cable and shift cable from cable bracket.
12. Remove control device assembly from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: Self tapping bolts are used to attach cables to the clutch housing.
^ Securely assemble each cable and lever of control shaft.
^ Be careful about the installation direction, and push control lever knob onto control lever.
CAUTION: Do not reuse control lever knob.
^ Make sure that the front/rear claws (1) of control device assembly are in contact with flange of the floor (2).
^ When control lever is selected to 1st-2nd side and 5th-6th side, confirm control lever returns to neutral position smoothly.
^ When control lever is shifted to each position, make sure there is no binding or disconnection in each boot.
^ Move stopper (1) to lock position when installing the shift cable onto the shift lever.