Removal And Installation

BACK DOOR LOCK


Removal and Installation


REMOVAL
1. Remove back door weather-strip. Refer to Removal and Installation.
2. Remove luggage rear plate. Refer to Removal And Installation.





3. Disconnect harness connector (A) of back door lock and remove the harness clip.
4. Remove mounting bolts (B) of back door lock and actuator bracket (1).
5. Disconnect connector of back door opener actuator.





6. Using a flat-bladed screwdriver (A) disconnect inside handle cable (1) from back door lock (2).
7. Remove back door lock and actuator bracket assembly.
8. Disconnect back door lock and back door opener actuator from back door lock and actuator bracket.
9. Remove following parts. Refer to Removal And Installation.
- Luggage floor carpet assembly
- Spare tire cover
- Luggage side finisher upper LH
- Luggage floor spacer center rear (without BOSE audio)
- Luggage spacer
- Luggage side box assembly LH
- Luggage rear plate
- Woofer (with BOSE audio)
10. Remove clips and remove inside handle assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
After installation, check back door open/close, lock/unlock operation.