Vehicle Security Operation Check

PRE-INSPECTION FOR DIAGNOSTIC


Vehicle Security Operation Check

1.INSPECTION START
Turn ignition switch "OFF" and pull out Intelligent Key from key slot.

NOTE:
Before starting operation check, open front windows.
- GO TO 2
2.CHECK SECURITY INDICATOR LAMP
1. Lock doors using Intelligent Key or mechanical key.
2. Check that security indicator lamp illuminates for 30 seconds.
Does the security indicator lamp illuminate?
YES - GO TO 3
NO - Perform diagnosis and repair. Refer to Component Function Check.
3.CHECK ALARM FUNCTION
1. After 30 seconds, security indicator lamp will start to blink.
2. Open any door before unlocking with Intelligent Key or mechanical key, or open trunk lid without Intelligent
Key or mechanical key.
Does the alarm function properly?
YES - GO TO 4
NO - Check the following.
- The vehicle security system does not phase in alarm mode. Refer to Vehicle Security System Symptoms.
- Alarm (horn, headlamp and hazard lamp) do not operate. Refer to Vehicle Security System Symptoms.
4.CHECK ALARM CANCEL OPERATION
Unlock any door or open trunk lid using Intelligent Key or mechanical key.
Does the alarm operation (horn, headlamp and hazard lamp) stop?
YES - Inspection End.
NO - Check door lock function. Refer to System Description.