Removal And Installation

REAR PARCEL SHELF FINISHER


Removal and Installation


REMOVAL
1. Remove the rear seat. Refer to Removal and Installation.
2. Remove high mounted stop lamp (if equipped). Refer to Removal And Installation.
3. Remove rear pillar finisher RH/LH. Refer to Service and Repair.
4. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf finisher.
5. Remove the clips, then remove rear parcel shelf finisher.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.