Removal and Replacement

CYLINDER HEAD


Removal and Installation







REMOVAL
1. Remove the timing chain. Refer to Service and Repair.
2. Remove the camshafts. Refer to Removal And Installation.
3. Remove spark plugs. Refer to Service and Repair.
4. Remove the front suspension member. Refer to Removal And Installation.
5. Disconnect the electric compressor. Refer to Service and Repair.





6. Remove cylinder head loosening bolts in the order as shown, using power tool.
7. If necessary to transfer to new cylinder head or remove for reconditioning, remove the intake manifold collector, intake manifold, and fuel tube assembly. Refer to Service and Repair.

INSPECTION AFTER REMOVAL

Outer Diameter of Cylinder Head Bolts
- Cylinder head bolts are tightened by plastic zone tightening method. Whenever the size difference between d1 and d2 exceeds the limit, replace the bolts with new ones.





Limit (d1 - d2) : 0.23 mm (0.0091 in) or less
- If reduction of outer diameter appears in a position other than d2, use it as d2 point.

INSTALLATION
1. Install a new cylinder head gasket.
2. Follow the steps below to tighten the cylinder head bolts in the numerical order as shown.
- Apply new engine oil to the threads and the seating surfaces of bolts.

CAUTION:
- If cylinder head bolts are re-used, check their outer diameters before installation. Follow the
Outer Diameter of Cylinder Head Bolts procedure.
- Check and confirm the tightening angle by using angle wrench or protractor. Avoid judgment by visual inspection without the tool.




















3. Installation of the remaining components is in the reverse order of removal.