Luggage Floor Trim

LUGGAGE FLOOR TRIM


Removal and Installation







REMOVAL

CAUTION:
- Insert a trim stick or suitable tool between panel on vehicle and clips (as indicated with arrow) to release clips.





- Use a trim stick or suitable tool when removing metal clips from garnishes.
- Be careful not to damage the body while prying to release clips.
- Make sure clips are properly aligned in panel holes on body when installing, then press them in completely.
1. Disconnect the negative battery terminal.
2. Open the rear doors and the back door.
3. Remove the rear seat cushion and seatback and seatback side RH/LH. Refer to Component Parts Drawing.
4. Lift and remove the luggage floor center board and luggage floor spacer.
5. Detach the tethers, then pull upward to remove the tonneau board.
6. Release the clips, then remove the striker cover and luggage rear plate.
7. Release the clips, then remove the luggage side lower finisher RH/LH.
- For LH side, disconnect cargo lamp connector.

INSTALLATION
Installation is in the reverse order of removal.