Trunk Room Trim & Trunk Lid Finisher

TRUNK ROOM TRIM and TRUNK LID FINISHER


Removal and Installation







REMOVAL

CAUTION:




- Insert a trim stick or suitable tool between panel on vehicle and clips (as indicated with arrow) to release clips.

- Be careful not to damage the body while prying to release clips.
- Make sure clips are properly aligned in panel holes on body when installing, then press them in completely.
1. Open trunk lid.
2. Position the rear seat cushion to the forward most position, then remove the rear seatback and seatback side RH/LH. Refer to Component Parts Drawing.
3. Release the clips, then remove the seatback finisher RH/LH.
4. Lift and remove the trunk floor carpet.
5. Release the clips, then remove the trunk rear plate.
6. Release the clips, then remove the trunk side finisher RH/LH.
7. Release the clips and remove the trunk lid finisher inner from the trunk lid.

INSTALLATION
Installation is in the reverse order of removal.