Removal and Installation

EXHAUST MANIFOLD


Removal and Installation


REMOVAL
1. Remove exhaust front tube. Refer to Component.
2. Remove exhaust manifold cover.





3. Remove the air fuel ratio sensor 1, using Tool (A).

Tool number :KV991J0050 (J-44626)


CAUTION:
Handle it carefully and avoid impacts.
4. Remove exhaust manifold side bolt of exhaust manifold stay.





5. Loosen nuts in reverse order as shown and remove exhaust manifold.

Arrow Indicates Engine front

CAUTION:
Cover engine openings to avoid entry of foreign materials.

INSPECTION AFTER REMOVAL

Surface Distortion
- Using straightedge (B) and feeler gauge (A), check the surface distortion of exhaust manifold mating surface in each exhaust port and entire part.










- If it exceeds the limit, replace exhaust manifold.

INSTALLATION
1. Install exhaust manifold gasket to cylinder head as shown.






Arrow Indicates Engine front

2. Tighten exhaust manifold nuts to specification in two stages in the numerical order shown.






Arrow Indicates Engine front

3. Install exhaust manifold stay (2) in the direction as shown.






1 : Exhaust manifold
A : Upper mark
Arrow Indicates Engine front

4. Install the air fuel ratio sensor 1, using Tool (A).






Tool number : KV991J0050 (J-44626)


CAUTION:
- Handle it carefully and avoid impacts.
- Before installing a new air fuel ratio sensor, clean the exhaust tube threads using suitable tool and approved anti-seize lubricant.
- Do not over-tighten the air fuel ratio sensor. Doing so may damage the air fuel ratio sensor, resulting in the MIL coming on.





5. Installation of the remaining parts is in the reverse order of removal.