Evaporator Temperature Sensor / Switch: Service and Repair

THERMO CONTROL AMPLIFIER


Removal and Installation


NOTE:
Only MR18DE - TYPE 2 systems are equipped with a thermo control amplifier.

REMOVAL
1. Remove evaporator. Refer to Service and Repair .

CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.





2. Mark the mounting position of the thermo control amp. and then remove thermo control amp. (1) from evaporator (2).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- Replace O-rings for A/C piping with new ones, and apply compressor oil when installing.
- Install the thermo control amp. at the mark made during removal of the thermo control amp.
- When recharging refrigerant, check for leaks.