Removal And Installation

CENTER CONSOLE ASSEMBLY


Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL
1. Remove shift knob (M/T models). Exploded View.
2. Remove console finisher assembly.










- A/T models
- Insert remover tool (A) between console finisher (1) and center console, lift up console finisher, and then disengage metal clips and pawls.
- Disconnect harness connectors.
- M/T models
- Pull up console finisher (2), and then disengage metal clips and pawls.
- Disconnect harness connector.





3. Remove console panel LH.





- Remove console panel LH (1) fixing screws (B).
- Pull the console panel LH crosswise.

Broken square indicates: Metal clip

4. Remove console panel RH.





- Remove console panel RH (1) fixing screws (B).
- Pull the console panel RH crosswise.

Broken square indicates: Metal clip






5. Remove center console fixing screws (A).





6. Disconnect console sub-harness connectors (A) and (B).





7. Remove cup holder assembly.
- Pull up cup holder assembly (1).
- Disconnect harness connectors.
- Remove harness clip.










8. Disconnect USB connector harness connector (A). (if equipped)





9. Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently.





10. Remove center console assembly.
- Put seat assembly (LH/RH) to the front-most position.
- Remove center console fixing screws (A).
- Put seat assembly (LH/RH) to the rear-most position.
- Lift up center console assembly back side, and then remove center console assembly.

INSTALLATION
Install in the reverse order of removal.