Removal And Installation

BODY SIDE TRIM


REAR SIDE FINISHER : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL
1. Slide seat assembly toward the frontmost position (driver or passenger side).
2. Remove kicking plate inner. Removal And Installation.
3. Remove body side welt from rear side finisher. Exploded View.
4. Remove the shoulder anchor. Removal And Installation.





5. Remove rear side finisher.
- Disengage rear side finisher fixing clips with a remover tool as shown in the figure.

Broken circle indicates: Clip

- Pull out carefully rear side finisher, and then disconnect side speaker connector located behind rear side finisher.
- Remove rear side finisher from body side panel.

INSTALLATION
Note the following item, and install in the reverse order of removal.

CAUTION:
When installing, check that all clips are securely fitted in panel holes on body, and then press them in.