Description

INSPECTION AND ADJUSTMENT


PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION : Description

Perform initialization of linear solenoid valve and calibration when the brake ECU, brake actuator or brake stroke sensor is replaced. Follow the procedure to perform initialization.

NOTE:
- If there is a problem with the auxiliary battery (12 V) voltage, initialization of linear solenoid valve and calibration cannot be completed normally. Make sure to check the auxiliary battery voltage before performing initialization of linear solenoid valve and calibration.
- If the actuator's temperature is high, initialization of linear solenoid valve and calibration may not be completed normally. In such a case, wait until the temperature decreases and then perform initialization of linear solenoid valve and calibration.
- If the ignition switch is turned OFF, the brake pedal is operated or vehicle speed is input while the linear solenoid valve offset learning is being performed, the learning will be cancelled.