Special Repair Requirement

INSPECTION AND ADJUSTMENT


PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION : Special Repair Requirement

1. Clear the stored value of linear solenoid valve and calibration data.
a. Turn the ignition switch OFF.
b. Connect the CONSULT-III.
c. Move the shift lever to the P position.
d. Turn the ignition switch ON with the brake pedal released.
e. Clear the stored value of initialization of linear solenoid valve and calibration. Diagnosis System (VDC/TCS/ABS Control Unit).
f. Using the CONSULT-III, perform initialization of linear solenoid valve and calibration.
2. Perform the initialization of linear solenoid valve and calibration.
a. Turn the ignition switch OFF.
b. Connect the CONSULT-III.
c. Move the shift lever to the P position.
d. Turn the ignition switch ON (READY) with the brake pedal depressed.

NOTE:
- If the linear solenoid valve offset learning is performed without turning the ignition switch ON, the learning process may not be completed properly because of insufficient auxiliary battery voltage.
- When the linear solenoid valve offset learning is interrupted, or the learning process is performed with the shift lever not in the P position, DTC C1345 will be stored.
e. Select "TEST MODE" in "WORK SUPPORT" to start TEST MODE.
f. Leave the vehicle stationary without depressing the brake pedal for 1 or 2 minutes.
g. Check that the interval between blinks of the Electronically Controlled Brake warning lamp changes from
1 second to 0.5 seconds.

NOTE:
- While the linear solenoid valve is learning, the Electronically Controlled Brake warning lamp blinks at intervals of 1 second. It blinks at intervals of 0.5 seconds after the completion of the learning.
- The time needed to complete initialization of linear solenoid valve and calibration varies depending on auxiliary battery voltage.
- The Electronically Controlled Brake warning lamp blinks at 1 second intervals during initialization of linear solenoid valve.
- The Electronically Controlled Brake warning lamp blinks 0.25 seconds intervals if the CONSULT-III prompts.
h. Select "TEST MODE END".